Back to 4x Serial to Ethernet Terminal Evaluation Kit Ordering Page The TEV-LB1 board carries a 128x96, 4-bit RITDISPLAY RGS13128096 OLED panel. This panel is based on a SOLOMON SSD1329 controller. Related datasheets, as well as the schematic diagram for the TEV-LB1 board can be found on Tibbo website. Interconnection between the EM1000 and the panel| Pin #(1) | EM1000 I/O line | Panel | | 5 | GPIO48 | --- | | 6 | GPIO47 | --- | | 7 | GPIO46 | --- | | 8 | GPIO39/P4.7 | D7 | | 9 | GPIO38/P4.6 | D6 | | 10 | GPIO37/P4.5 | D5 | | 11 | GPIO36/P4.4 | D4 | | 12 | GPIO35/P4.3 | D3 | | 13 | GPIO34/P4.2 | D2 | | 14 | GPIO33/P4.1 | D1 | | 15 | GPIO32/P4.0 | D0 | | 16 | GPIO44 | RST | | 17 | GPIO43 | D/C | | 18 | GPIO42 | R/W | | 19 | GPIO41 | E | | 20 | GPIO40 | CS |
Pin number 1 on the TEV-LB1 connector. Required initialization code in Tibbo BASIC applicationFor correct panel operation, click Project, Settings, and select EM1000 or EM1000W platform. Additionally, click Customize to open a Customize Platform dialog. In the dialog, double-click the Display Panel Type line and choose Solomon SSD1329 (Ritdisplay RGS13128096). The following initialization code should also be added to your project:
lcd.iomapping = 44,43,42,41,40,4 RST,DC,WR,RD,CS,data_bus
(W is marked R/W on the schematic diagram, RD is marked E)
io.num=PL_IO_NUM_40
io.enabled=YES
io.num=PL_IO_NUM_41
io.enabled=YES
io.num=PL_IO_NUM_42
io.enabled=YES
io.num=PL_IO_NUM_43
io.enabled=YES
io.num=PL_IO_NUM_44
io.enabled=YES
lcd.width=128
lcd.height=96
lcd.rotated=NO
lcd.inverted=NO
lcd.enabled=YES
Back to 4x Serial to Ethernet Terminal Evaluation Kit Ordering Page
|
