Go to ARM Development Suite order page

Atmel AT91SAM9263 is supported, as follows:

AT91SAM9263

• Controller Area Network (CAN)
• Chip Configuration
• LCD controller
• Bus matrix
• Pulse width modulator (PWM)
• Periodic interval timer (PIT)
• Ports (PIOA, PIOB, PIOC, PIOD and PIOE)
• Power management controller (PMC)
• Reset controller
• SDRAM controllers (SDRAMC0 and SDRAMC1)
• Static memory controllers (SMC0 and SMC1)
• Serial peripheral interfaces (SPI0 and SPI1)
• Synchronous serial controllers (SSC0 and SSC1)
• System interrupt
• Timer/counters
• Two-wire interface (TWI)
• Universal synchronous/asynchronous receiver/transmitters (USART0, USART1 and USART2)
• USB device port (UDP)
• Watchdog timer

Context menu Code Creation Wizards:

• 2D graphics controller
• AC97 audio interface
• Advanced interrupt controller (AIC)
• Controller Area Network (CAN)
• Chip configuration
• Debug unit
• DMA controller (DMAC)
• Error-corrected code (ECC0 and ECC1)
• Ethernet MAC (EMAC)
• Image sensor interface
• Bus matrix
• MultiMedia Card interfaces (MCI0 and MCI1)
• Pulse width modulator (PWM)
• Periodic interval timer (PIT)
• Ports (PIOA, PIOB, PIOC, PIOD and PIOE)
• Power management controller (PMC)
• Reset controller
• Real-time timers (RTT0 and RTT1)
• SDRAM controllers (SDRAMC0 and SDRAMC1)
• Shutdown controller
• Static memory controllers (SMC0 and SMC1)
• Serial peripheral interfaces (SPI0 and SPI1)
• Synchronous serial controllers (SSC0 and SSC1)
• System interrupt
• Timer/counters
• Two-wire interface (TWI)
• Universal synchronous/asynchronous receiver/transmitters (USART0, USART1 and USART2)
• USB device port (UDP)
• Watchdog timer

Source-level ARM instruction set simulation

Simulation of the memory management unit (MMU) and fast context switch extension (FCSE)

Peripheral simulation:

• PLL
• Advanced interrupt controller
• Ports
• Timer/counters
• Universal synchronous/asynchronous receiver/transmitters (USART0, USART1 and USART2)

Source-level on-chip debugging with included Jaguar USB JTAG interface

• Automatically detects boot mode and configures SRAM or programs Flash
• Debugging with the memory management unit (MMU) and fast context switch extension (FCSE) enabled

Go to ARM Development Suite order page