Go to ARM Development Suite order page

Atmel AT91SAM9260 is supported, as follows:

AT91SAM9260

• A/D converter (ADC)
• Chip Configuration
• Periodic interval timer (PIT)
• Ports (PIOA, PIOB and PIOC)
• Power management controller (PMC)
• Reset controller
• SDRAM controller (SDRAMC)
• Static memory controller (SMC)
• Serial peripheral interfaces (SPI0 and SPI1)
• Synchronous serial controller (SSC)
• System interrupt
• Timer/counters
• Two-wire interface (TWI)
• Universal synchronous/asynchronous receiver/transmitters (USART0, USART1, USART2, USART3, USART4 and USART5)
• USB device port (UDP)
• Watchdog timer

Context menu Code Creation Wizards:

• A/D converter (ADC)
• Advanced interrupt controller (AIC)
• Chip configuration
• Debug unit
• Error-corrected code (ECC)
• Ethernet MAC (EMAC)
• Image sensor interface
• Bus matrix
• MultiMedia Card interface (MCI)
• Periodic interval timer (PIT)
• Ports (PIOA, PIOB and PIOC)
• Power management controller (PMC)
• Reset controller
• Real-time timer
• SDRAM controller (SDRAMC)
• Shutdown controller
• Static memory controller (SMC)
• Serial peripheral interfaces (SPI0 and SPI1)
• Synchronous serial controller (SSC)
• System interrupt
• Timer/counters
• Two-wire interface (TWI)
• Universal synchronous/asynchronous receiver/transmitters (USART0, USART1, USART2, USART3, USART4 and USART5)
• USB device port (UDP)
• Voltage regulator
• Watchdog timer

Source-level ARM instruction set simulation

Simulation of the memory management unit (MMU) and fast context switch extension (FCSE)

Peripheral simulation:

• PLL
• Advanced interrupt controller
• Ports
• Timer/counters
• Universal synchronous/asynchronous receiver/transmitters (USART0, USART1, USART2, USART3, USART4 and USART5)

Source-level on-chip debugging with included Jaguar USB JTAG interface

• Automatically detects boot mode and configures SRAM or programs Flash
• Debugging with the memory management unit (MMU) and fast context switch extension (FCSE) enabled

Go to ARM Development Suite order page